Kingston KVR1333D3N9/1G featured standard 128M X 64 Non-ECC 1333MHz 240-pin Unbuffered DIMM (DDR3, 1.5V, CL9, FBGA, Gold)
Kingston KVR1333D3N9/1G describes ValueRAM's 128M x 64-bit 1GB (1024MB) DDR3-1333 CL9 SDRAM (Synchronous DRAM) memory module, based on eight 128M x 8-bit DDR3-1333 FBGA components. The SPD is programmed to JEDEC standard latency 1333Mhz timing of 9-9-9 at 1.5V. This 240-pin DIMM uses gold contact fingers and requires +1.5V.
Features
JEDEC standard 1.5V ± 0.075V Power Supply
VDDQ = 1.5V ± 0.075V
667MHz fCK for 1333Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 5,6,7,8,9,10
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 9(DDR3-1333)
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4
which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower then TCASE 85°C, 3.9us at 85°C < TCASE . 95°C
Asynchronous Reset
1066Mbps CL7 doesn’t have backward compatibility with 800Mbps CL5
PCB : Height 1.180” (30.00mm), double sided componentSpecifications
Capacity
: 1 GB
Type
: DRAM
Technology
: DDR3 SDRAM
Form Factor
: DIMM 240-pin
Speed
: 1333 MHz
Latency Timings
: CL9
Data Integrity Check
: Non-ECC
RAM Features
: Unbuffered
Module Configuration
: 128 x 64
Supply Voltage
: 1.5 V
Lead Plating
: Gold
CL(IDD)
: 9 cycles
Row Cycle Time (tRCmin)
: 49.5ns (min.)
Refresh to Active/Refresh Command Time (tRFCmin)
: 110ns
Row Active Time (tRASmin)
: 36ns (min.)
Power
: 1.296 W (operating)
UL Rating
: 94 V - 0
Operating Temperature
: 0o C to 85o C
Storage Temperature
: -55o C to +100o C
|
Spanish version
Newsletter
Description:
Calculate shipping cost
